by LaunchAdmin | Jul 28, 2020
There are three LED indicators on the base station, when all three LEDs are lit solidly, this means the base station is working correctly. If not all LEDs are lit, follow these diagnostic steps: Connect a working power supply to base station, if the power LED does not...
by LaunchAdmin | Jul 28, 2020
The auto answer feature for Yealink DECT phones only works when the phone is placed in its charging cradle. When auto answer feature is enabled, you can simply answer the incoming calls by lifting the handset from the charging cradle To configure auto answer: Press OK...
by LaunchAdmin | Jul 28, 2020
When a DECT repeater is installed in the environment, the system produces a verification tone to confirm that the handset is operational in the extended range. You can activate/deactivate the verification tone on the Repeater by following these steps: Switch off the...
by LaunchAdmin | Jul 28, 2020
Check the assignment rule under Account → Number Assignment. Ensure that the extension has been assigned to the handset under the incoming call rule.
by LaunchAdmin | Jul 28, 2020
Press and hold the “*” button to set the handset to silent mode. To enable normal mode, press and hold the “*” button.
by LaunchAdmin | Jul 28, 2020
Connect the base station to the network and power. Register a handset to the base station. Use the handset to locate the IP Address: Handset menu → Status → Base Enter this IP address in your web browser.
by LaunchAdmin | Jul 28, 2020
The Yealink W52P handset uses a 2.5mm headset jack. However, this is a non-standard interface and requires special headsets. Please purchase 2.5mm headsets in the following standard (MONO/Dual MONO). MONO Dual MONO The Yealink W53H and W56P handsets uses a 3.5mm...
by LaunchAdmin | Jul 28, 2020
All Yealink DECT products use the CAT-iq 2.0 standard. However, to enhance the feature set of the Yealink phone, there have been some modifications to the standard. You may be able to register other handsets to the Yealink DECT base stations, but all of the features...
by LaunchAdmin | Jul 28, 2020
During the upgrade process, it is advisable to place the handset in the charging cradle and closer (within 10 meters) to the base station. While the handset is busy upgrading, you will not be able to use any of the features of the phone. A firmware upgrade can take...